An agitator or pulsator that moves freely may have a damaged connection to the shaft, but some designs also have normal partial movement. Inspection requires identifying the part and how it receives movement.
What assembly is inside the tub
It may be a low-profile plate or impeller, a one-piece agitator or a multi-section assembly. Fasteners, couplings and internal mechanisms vary between models; they don’t all contain the same pawls.
If the machine simply "fills without agitating", that symptom needs a broader diagnosis. In a twin-tub washer with no wash movement, its specific controls and drive system also matter.
How to distinguish wear from a lack of drive
A technical inspection should determine whether movement reaches the shaft, whether the fastener transfers it to the assembly, and whether any section is damaged. Worn splines may affect the part’s housing, the shaft or both.
If the shaft isn’t receiving the expected movement, replacing the plate won’t fix the fault: the drive systemneeds to be checked. Don’t run the washing machine with guards or interlocks bypassed to observe it.
Removal and replacement
Only remove it by following the applicable instructions, with the power isolated and the assembly stopped. A stuck part shouldn’t be prised against the tub or removed by hitting the shaft.
Replacement should restore the intended connection, fastening and movement, using the correct assembly. Being able to lift a decorative cap easily doesn’t mean the entire agitator is designed to be removed by the user.
A new part fitted over damaged shaft splines may still slip; it’s worth checking both sides of the connection before ordering a replacement.
View all articles in Washing machine component diagnosis and repair
