Irregular acceleration may make it necessary to check the rotation information, but it does not by itself identify a faulty sensor. First, determine how the drive for that model obtains this information.
Three architectures that are not interchangeable
Some motors use a tachogenerator; others have Hall sensors, and some controls estimate rotation without a separate, replaceable sensor. The parts diagram and schematic determine which one is present and whether it is supplied separately from the motor.
This component provides information about motor movement. It should not be confused with a vibration sensor or with the appliance deciding to limit the spin cycle for other reasons.
Trace the signal to the control
- Identify the specified sensor, mounting and connections.
- Check the wiring and connectors using the power-off procedure.
- Check the signal and its operating conditions against the technical documentation.
- Assess how it is received by the electronic module and whether the drive produces the requested movement.
Jerking, loss of acceleration or a related code can point to this area, but may also occur with faults in the motor and its control. The meaning of a code depends on the manufacturer and model.
Testing limitations
A measurement requires the conditions, terminals and values specific to that circuit. Active signals and any powered testing should be left to qualified personnel with the appropriate equipment. Do not swap terminals or test resistance using values published for another product family.
Before replacing the sensor, the diagnosis should distinguish a genuine absence of signal from a wiring interruption or a reading fault in the control.
