F7 E1 indicates a speed-sensing problem on the documented Whirlpool front-load washer: the motor does not reach the speed required by the cycle.
If it has just been installed or the load has changed
The manufacturer’s documentation recommends checking the transport bolts and for an overloaded load. If the first wash fails, check the unpacking section of the manual and confirm that the installer removed the specified transport bolts. Do not run the machine to see what happens with them still in place.
If the error started with an especially large load, stop the cycle, wait for the door to unlock and reduce the load to suit the programme. A bulky item does not become suitable just by selecting a higher spin speed.
What the code describes and what still needs diagnosing
F7 E1 describes a speed that the control cannot confirm. On its own, it does not prove that the motor, a sensor or the electronics are faulty. Note whether the drum tries to turn, whether the fault appears at start-up or during the spin cycle, and whether it started after the machine was moved.
Only retry as directed on the control panel after correcting the accessible condition. If the error returns, arrange a service call. The explanation of the speed sensor helps explain what the technician needs to check; there is no need to measure circuits or dismantle the motor.
Stop using the machine if it makes unusual banging noises when trying to turn or if it moves.
View all articles in Whirlpool washing machine error codes and alerts
