Maytag washer error F7 E1: motor speed not reached

F7 E1 on the documented Maytag front-loader indicates that the speed required for the cycle has not been reached. The initial checks depend on the installation and load.

What happened before the first alert

The manufacturer’s documentation recommends checking for an overloaded load and any shipping bolts. If the washer has just been installed, check the preparation section of the manual and make sure the specified shipping bolts have been removed. Don’t identify bolts by appearance or remove cabinet parts to test.

If the problem started with a large load, pause the cycle, wait for the door to unlock normally and reduce the amount of washing in line with the programme. Also check that a bulky item is suitable for that cycle; drum size is not the only limit.

Information for diagnosing the speed issue

Note whether the drum does not move at all, turns at the start or fails as it speeds up. These observations describe what is happening; they do not confirm that a Hall sensor, the motor or the control board is faulty.

Only try again as permitted by the control panel after checking the accessible conditions. If F7 E1 appears again, request service. The motor speed detection guide explains the function involved without treating the code as an instruction to replace a part.

If there is heavy banging, stop using the washer and report that symptom along with the code.

View all articles in Maytag washer error codes and alerts