OL on a compatible Maytag HE top-load washer indicates that the load is too large. Remove items, observing the capacity limit for the selected cycle.
What to check before starting again
The manufacturer's documentation explains that an overload detection may result in the water and detergent being drained. Wait for the door to unlock normally, reduce the load and check the cycle status before adding detergent again.
If you're unsure whether draining has finished, don't automatically add another dose. The manual explains how to proceed in that situation. Wet clothes may also retain detergent even when there's no visible water in the drum.
Capacity depends on the cycle
Use the dry-clothing limit shown in the table for the selected cycle. The appliance's general maximum capacity doesn't apply to every cycle. Bulky items can prevent the load from moving, even if it weighs far less than the maximum.
After removing items, distribute the remaining clothes loosely. If the load fits correctly but forms an uneven lump, check the imbalance troubleshooting steps in the Maytag guide. The guide to load size and distribution explains both conditions.
If OL appears again with loads within the stated limits, tell the service team which cycle you used and what type of items were in the load. Don't repeatedly add and remove clothes in an attempt to hide the warning.
Reducing an overloaded load restores room for movement; compressing it inside the drum won't fix the problem.
