F7 E1 on the documented Maytag front-load washer indicates that the speed required for the cycle has not been reached. The initial checks depend on the installation and load.
What happened before the first warning
The manufacturer's documentation recommends checking for an overloaded load and transport materials. If the washer was recently installed, check the preparation section of the manual and confirm that the designated transport restraints have been removed. Do not identify bolts by appearance or remove cabinet parts to test the washer.
If the problem appeared with a large load, pause the cycle, wait for the door to unlock normally and reduce the load in line with the programme. Also check that bulky items are permitted in that cycle; drum size is not the only limit.
Details to help diagnose the speed issue
Note whether the drum does not move at all, turns at the start or fails when the speed increases. These observations describe the behaviour; they do not confirm that a Hall sensor, motor or control board is faulty.
Only make the retry permitted by the control panel after checking the accessible condition. If F7 E1 appears again, request assistance. The motor speed detection guide explains the function involved without treating the code as an instruction to replace a part.
If there are severe impacts, stop using the washer and report this symptom along with the code.
View all articles in Maytag washing machine error codes and alerts
