On the documented LG front-loaders, dE/dE1/E01 and dE2/E30 correspond to two door-closing situations: the door is not properly closed, or it is closed but the lock is not confirmed.
| Message | Indicated status |
|---|---|
| dE, dE1, E01 | Door not fully closed. |
| dE2, E30 | Door closed, but lock not confirmed. |
These associations appear in the official front-loader help. The mechanical click of the door does not prove that the electronics have received the confirmation needed to start.
Check around the door seal
With the drum stopped and the door unlocked, move any clothing caught between the seal and the door out of the way. Check whether an item is pressing from the inside or whether there is visible damage to the latch. Close the door normally, without slamming it, holding it under pressure or bypassing the lock.
If there is already water in the machine or the cycle was hot, do not try to open the door to repeat this check until the machine allows it. A recovery procedure authorised by the manual may clear a temporary fault; if the code returns, that does not prove the door lock has been repaired.
For a lower drawer, use the SideKick door-lock guide. The guide to a door that will not open or close covers the other access issues.
When requesting a service check, specify whether the door is physically closed and whether the message appears before water enters or during the cycle.
View all articles in LG washing machine error codes and messages
