On the documented LG front-load models, dE/dE1/E01 and dE2/E30 correspond to two door-closing situations: the door is not fully closed, or the door is closed but the lock is not confirmed.
| Message | Indicated status |
|---|---|
| dE, dE1, E01 | Door not fully closed. |
| dE2, E30 | Door closed, but lock not confirmed. |
These associations appear in the official front-load help. The mechanical click of the door does not prove that the electronics have received the confirmation needed to start.
Check around the door seal
With the drum stopped and the door unlocked, move any clothing caught between the seal and the door out of the way. Check whether a garment is pressing against the door from inside or whether there is visible damage to the latch. Close the door normally, without slamming it, holding it under pressure or bypassing the lock.
If there is already water in the washer or the cycle was hot, do not try to open the door to repeat this check until the washer allows you to. A recovery procedure authorized by the manual may clear a temporary fault; if the code returns, that does not prove the door lock has been repaired.
For a lower drawer, use the SideKick door-lock guide. The article on a door that won’t open or close covers the other access issues.
When requesting a service inspection, note whether the door closes physically and whether the message appears before water starts filling or during the cycle.
