On the documented LG front-load models, dE/dE1/E01 and dE2/E30 correspond to two door-closing situations: the door is not properly closed, or it is closed but the lock is not confirmed.
| Message | Indicated status |
|---|---|
| dE, dE1, E01 | Door not fully closed. |
| dE2, E30 | Door closed, but lock not confirmed. |
These associations appear in the official front-load help. The mechanical click of the door does not prove that the electronics have received the confirmation needed to start.
Check around the door seal
With the drum stopped and the door unlocked, move any clothing caught between the seal and the door out of the way. Check for clothing pressing against the door from inside or visible damage to the latch. Close it normally, without slamming it, holding it under pressure or bypassing the lock.
If there is already water in the machine or the programme was running hot, do not try to open the door to repeat this check until the machine allows you to. A recovery procedure permitted by the manual may clear a temporary fault; if the code returns, that does not prove the door lock has been repaired.
For a lower drawer, use the SideKick door-lock guide. The door that will not open or close covers the other access issues.
When requesting an inspection, specify whether the door closes physically and whether the warning appears before water enters the machine or during the cycle.
View all articles in LG washing machine error codes and alerts
