No TAP indicates that no water is reaching the documented Fisher & Paykel WashSmart/QuickSmart front loaders. Check the cold water supply and installation before assuming the solenoid valve is faulty.
The WH7560P1/WH8560P1 and WH7560J1/WH8560J1 manual confirms the warning. These model families may be installed with cold water only, in accordance with their instructions; two water connections are not required for all Fisher & Paykel machines.
Check the connection required by your machine
Check the tap and the hose route. Confirm that cold water reaches the corresponding cold water inlet; connecting to the wrong inlet can leave the required circuit without a water supply.
Accessible screens can be checked as part of the model's maintenance procedure, after turning off the water supply and disconnecting the power. If water enters and then drains away, check the drain: a position that encourages siphoning can prevent the machine from filling.
See water supply requirements and installation connections for more information about this work. If No TAP persists with the machine correctly installed and supplied, arrange an inspection of the filling system rather than replacing parts based on the warning text.
Tell support whether the installation uses one or two water connections, and which one is connected to the cold water inlet.
View all articles in Fisher & Paykel washing machine codes and alerts
