No TAP indicates that water is not reaching the documented Fisher & Paykel WashSmart/QuickSmart front-loaders. Check the cold-water supply and installation before assuming a faulty solenoid valve.
The WH7560P1/WH8560P1 and WH7560J1/WH8560J1 manual confirms the warning. These model families may be installed with a cold-water-only supply, as specified in their instructions; two water connections are not required for every Fisher & Paykel machine.
Check the connection required by the machine
Check the tap and the route of the hose. Confirm that cold water reaches the corresponding cold-water inlet; connecting it to the wrong inlet can leave the required circuit without a water supply.
Accessible mesh filters should be checked as part of the model-specific maintenance, after turning off the water supply and disconnecting the power. If water enters and then drains away, check the drain: its position may encourage siphoning and prevent the machine from filling.
See water supply requirements and installation connections for more information on this work. If No TAP persists despite correct installation and water supply, request an inspection of the filling system rather than replacing parts based on the warning text.
Tell support whether the installation uses one or two water connections, and which one is connected to the cold-water inlet.
View all articles in Fisher & Paykel washing machine codes and alerts
