No TAP indicates that water is not reaching the documented Fisher & Paykel front-load WashSmart/QuickSmart models. Check the cold-water supply and installation before assuming a faulty solenoid valve.
The WH7560P1/WH8560P1 and WH7560J1/WH8560J1 manual confirms the alert. On these families, a cold-water-only installation may be permitted according to the instructions; two connections are not required on all Fisher & Paykel machines.
Check the connection the appliance needs
Check the valve and hose routing. Make sure cold water reaches the correct cold-water inlet; a connection to the wrong inlet can leave the required circuit without supply.
Accessible strainers are checked through the model’s maintenance procedure, after shutting off the water supply and disconnecting power. If water enters and the alert disappears, check the drain: a setup that encourages siphoning can prevent filling.
See the supply requirements and the installation connections for more detail on those tasks. If No TAP persists with the installation and water supply correct, request a filling inspection without replacing parts based only on the message.
Tell support whether the installation uses one or two taps and which one is connected to the cold-water inlet.