No TAP warning on Fisher & Paykel washing machines: no water supply

No TAP indicates that water is not reaching the documented Fisher & Paykel WashSmart/QuickSmart front-load washers. Check the cold-water supply and installation before assuming a faulty solenoid valve.

The WH7560P1/WH8560P1 and WH7560J1/WH8560J1 manual confirms the warning. These model families may be installed with cold water only, as specified in their instructions; two water inlets are not required on every Fisher & Paykel washer.

Check the connection the washer requires

Check the tap and the hose route. Confirm that cold water reaches the corresponding cold-water inlet; connecting it to the wrong inlet can leave the required circuit without a water supply.

Accessible filters can be checked as part of the model-specific maintenance procedure, after shutting off the water supply and disconnecting the power. If water enters and then drains away, check the drain: a position that encourages siphoning can prevent the washer from filling.

See the water supply requirements and the installation connections for more information about this work. If No TAP persists despite correct installation and water supply, request an inspection of the filling system rather than replacing parts based on the warning text.

Tell support whether the installation uses one or two inlets, and which one is connected to the cold-water inlet.

View all articles in Fisher & Paykel washer codes and alerts