No TAP warning on Fisher & Paykel washing machines: water supply failure

No TAP indicates that water is not reaching the documented Fisher & Paykel WashSmart/QuickSmart front loaders. Check the cold-water supply and installation before assuming that the solenoid valve is faulty.

The WH7560P1/WH8560P1 and WH7560J1/WH8560J1 manual confirms the warning. These ranges may allow installation with cold water only, in accordance with their instructions; two water inlets are not required on every Fisher & Paykel model.

Check the connection required by the appliance

Check the tap and the hose route. Confirm that cold water reaches the corresponding cold inlet; connecting to the wrong inlet can leave the required circuit without a water supply.

Accessible mesh filters should be checked as part of the model’s maintenance procedure, after turning off the water supply and disconnecting the power. If water enters and the warning clears, check the drain: a position that encourages siphoning can prevent the machine from filling.

See the water supply requirements and the installation connections for more information on this work. If No TAP persists despite correct installation and water supply, request an inspection of the filling system rather than replacing parts based on the warning text.

Tell support whether the installation uses one or two inlets, and which one is connected to the cold inlet.

View all articles in Fisher & Paykel washing machine codes and alerts