Sud LOC indicates a pause related to excess foam on the documented Fisher & Paykel front loaders. Allow the intended recovery process to finish before treating the extended cycle as a fault.
The WH7560P1/WH8560P1 and WH7560J1/WH8560J1 manual describes an automatic ten-minute wait before resuming. This behaviour applies to those model families, not all Fisher & Paykel machines.
What to do during the pause
If there is no leak or other alarm, follow the recovery steps in the manual without adding detergent or homemade anti-foam products. Opening the machine or switching it off to shorten the wait may interrupt the intended process.
If there is water outside the machine, address the leak and avoid contact with wet electrical components. Don’t keep waiting just because Sud LOC is a foam warning.
Adjust your detergent use before the next wash
Check that the detergent is suitable for front loaders and measure the dose according to the product, load size and soil level. A more concentrated formula or a small load may require less detergent. See detergent dosing and foam control to adjust these habits.
If the warning recurs after you have adjusted your detergent use and completed the approved recovery process, arrange an inspection; don’t assume that foam alone means the pump is damaged.
Record how much detergent you added and whether any residue was left from a previous wash, so you can explain a recurring Sud LOC warning.
View all articles in Fisher & Paykel washing machine codes and alerts
