Drying in a washer-dryer: condensation, venting and heat pump

Drying evaporates water from clothes and must remove that moisture from the air. Depending on the design, washer-dryers can condense it within the circuit or vent humid air outdoors.

Heating and removing moisture are different functions

A fan moves air through the load. Heat encourages evaporation; the system then needs to remove moisture so the air can continue drying. The heat source and the method of moisture removal should not be confused.

Integrated drying principles
DesignMoisture removalCondition to check
Water-cooled condensationVapour is condensed by cooling with waterWater supply and drainage during drying
Air-cooled condensationHeat exchange with a separate airflow pathVentilation and temperature at the installation location
Vented dryingHumid air exits through the designated ductCompatible outdoor vent
Heat pumpA refrigerant circuit cools and reheats the airCondensate management and specified maintenance

The LG manual for the F4X7*FPY* range requires the cold-water tap to remain open during drying; GE documents a washer-dryer with a heat pump. These examples show why it cannot be claimed that all washer-dryers use water while drying.

What this means for the space

The manual should confirm the system actually installed and the access needed to clean filters or other specified parts of the system. An integrated cabinet must meet its thermal requirements. Washing and drying consumption should be compared by phase and for equivalent capacities.

If the appliance no longer dries as well as before, continue to diagnosing poor drying. Explaining the mechanism does not authorise work on a refrigerant circuit.

Keep the supplies and airflow paths required by the identified technology available; do not copy the requirements of another washer-dryer.

View all articles in Washing technologies: motors, sensors and automation