Drying in a washer-dryer: condensation, venting and heat pumps

Drying evaporates water from clothes and must remove that moisture from the air. Depending on the design, washer-dryers can condense it inside the system or vent humid air outdoors.

Heating and removing moisture are different functions

A fan moves air through the load. Heat promotes evaporation; the system then needs to remove moisture so the air can continue drying. The heat source and the method of removing moisture should not be confused.

Integrated drying principles
DesignMoisture removalCondition to check
Water-cooled condensationSteam condenses through water coolingWater supply and drainage during drying
Air-cooled condensationHeat exchange with a separate airflow pathVentilation and installation-area temperature
VentingHumid air exits through the designated ductCompatible outdoor vent
Heat pumpA refrigerant circuit cools and reheats the airCondensate management and specified maintenance

The LG F4X7*FPY* family manual requires the cold-water tap to remain open during drying; GE documents a heat-pump washer-dryer. These examples show why it cannot be stated that all washer-dryers use water during drying.

What this means for the space

The manual should confirm which system is actually installed and the access needed to clean the specified filters or circuits. A built-in cabinet must meet its thermal requirements. Washing and drying energy consumption should be compared by phase and at equivalent capacities.

If the appliance no longer dries as well as it used to, continue to troubleshooting poor drying. Explaining the mechanism does not authorize work on a refrigerant circuit.

Keep the supplies and airflow paths required by the identified technology available; do not copy the requirements of another washer-dryer.

View all articles in Laundry technologies: motors, sensors and automation