Drying in a washer-dryer: condensation, venting and heat pump

Drying evaporates water from clothes and must remove that moisture from the air. Depending on the design, washer-dryers can condense it within the system or vent moist air outside.

Heating and removing moisture are different functions

A fan moves air through the load. Heat promotes evaporation; the system then needs to remove moisture so the air can keep drying. The heat source and the method of moisture removal should not be confused.

Integrated drying principles
DesignMoisture removalCondition to check
Water-cooled condensationVapour is condensed by cooling with waterWater supply and drainage during drying
Air-cooled condensationHeat exchange with another air pathVentilation and temperature at the installation location
VentingMoist air exits through the designated ductCompatible outdoor outlet
Heat pumpA refrigerant circuit cools and reheats the airCondensate management and specified maintenance

The LG manual for the F4X7*FPY* range requires the cold tap to remain open during drying; GE documents a heat-pump washer-dryer. These examples show why it cannot be claimed that all washer-dryers use water while drying.

What this means for using the space

The manual should confirm the system actually installed and provide access for cleaning filters or specified circuits. An integrated cabinet must meet its thermal requirements. Washing and drying consumption should be compared by phase and equivalent capacity.

If the appliance stops drying as well as it used to, continue to troubleshooting poor drying. Explaining the mechanism does not authorise work on a refrigerant circuit.

Keep the supplies and air paths required by the identified technology available; do not copy the requirements for another washer-dryer.

View all articles in Washing technologies: motors, sensors and automation