Washer-dryer consumption: measure washing and drying separately

The washing-only figure does not describe the consumption for washing and drying. Compare the capacity, energy, water and duration of each mode separately, using the same load and final result.

Check both functions on the product information sheet

A washer-dryer may specify one limit for washing and another for the complete cycle. The European label for washer-dryers distinguishes between washing and complete-cycle information; other markets use their own formats. Do not automatically add two figures without checking what each one includes.

If the energy figure for the complete cycle already includes washing, adding the washing consumption again counts it twice. If drying has been measured separately, record the incoming moisture level so that the comparison is meaningful.

Include all the loads needed

When the drying limit means the load has to be split, the total consumption includes all the loads. The way an all-in-one appliance is organised can affect how soon it is available, even if one phase uses little energy.

Hypothetical example: a 0.6 kWh wash followed by two drying cycles of 1.4 kWh each adds up to 3.4 kWh. At a variable tariff of 0.25 monetary units/kWh, that comes to 0.85 monetary units. These are not figures for a specific model or typical performance.

Water and residual moisture

The drying system determines whether it can use water for condensation; this is not the case for all washer-dryers. Record the total water used for the process.

The amount of water retained by the clothes after spinning affects the heat required afterwards. Compare equivalent programmes, loads and drying levels. For the complete tariff calculation method, use energy and cost per cycle.

Count all the phases and loads needed to deliver the same clothes in the same final condition.

View all articles in Washing machine efficiency: electricity, water and sustainability