Drying in a washer-dryer: condensation, venting and heat pump

Drying evaporates water from clothes and must remove that moisture from the air. Depending on the design, washer-dryers can condense it within the system or vent moist air outside.

Heating and removing moisture are different functions

A fan moves air through the load. Heat encourages evaporation; the system then needs to remove moisture so the air can continue drying. The heat source and the method of moisture removal should not be confused.

Integrated drying principles
DesignMoisture removalCondition to check
Water-cooled condensationSteam is condensed by cooling with waterWater supply and drainage during drying
Air-cooled condensationHeat exchange with a separate air pathVentilation and ambient temperature
VentingMoist air exits through the designated ductCompatible external outlet
Heat pumpA refrigeration circuit cools and reheats the airCondensate management and specified maintenance

The LG F4X7*FPY* family manual requires the cold tap to remain open during drying; GE documents a washer-dryer with a heat pump. These examples show why it cannot be claimed that all washer-dryers use water when drying.

What this means for the space

The manual should confirm the system actually installed and the access needed to clean the specified filters or circuits. An integrated cabinet must meet its thermal requirements. Washing and drying consumption should be compared by phase and equivalent capacity.

If the appliance no longer dries as well as it used to, continue with troubleshooting poor drying. Explaining the mechanism does not authorise work on a refrigeration circuit.

Keep the supplies and air paths required by the identified technology available; do not copy the requirements for a different washer-dryer.

View all articles in Washing technologies: motors, sensors and automation