Some systems use water during drying, but any visible build-up should not be considered normal. If the water level rises enough to wet the clothes again, check the water inlet and drainage, as applicable to the design.
Water supply as intended does not mean the drum should flood
In water-cooled condensation systems, the water supply helps remove moisture from the air, and the circuit drains the resulting water. Not all appliances work this way; a heat-pump model may have other functions that also use water.
For example, the LG F4X7*FPY* manual requires the cold-water tap to remain open during its drying cycles. This instruction applies to the documented product range and does not define how all washer-dryers work.
What to note if water builds up
- Whether water appears before drying or increases after the cycle starts.
- Whether you can hear the pump, and whether drainage worked at the end of the wash.
- Whether water continues to enter after you stop the appliance.
- Whether there is an alert, water flowing back from a pipe, or a visible leak.
A drainage failure can leave water in the circuit. If the water supply does not shut off, the valve should be assessed; the drying circuit should be checked if the issue depends on how it manages condensate.
Do not turn off the tap as a routine solution without checking the manual. If the water level rises uncontrollably, stop using the appliance and safely shut off the water supply to contain the leak.
Do not assume it is normal for the clothes to get soaked again just because the appliance uses water during drying: an abnormal water level needs to be diagnosed.
View all articles in Washer-dryer not drying properly: diagnosis by system
