Diagnosing the air and heat circuit in a washer-dryer

When a washer-dryer does not dry properly, internal diagnosis should check how air circulates, how it is heated and how moisture is removed. The order of checks depends on the system fitted and the confirmed symptom.

Identify the system in the washer-dryer

A unit with a heating element, one that vents air and one with a heat pump cannot be checked as though they were identical. The manual and parts diagram identify the relevant fan, ducts, sensors and condensate management system.

Before dismantling, rule out inadequate drying and a prolonged or interrupted programme. Damp laundry caused by the load or programme selection does not indicate a fault with the heater.

What the inspection should distinguish

  • Air circulation: airflow path, blockages and fan operation.
  • Heat generation: components and controls specific to the system design.
  • Thermal sensing and protection: sensors, connections and conditions that trigger a cut-out.
  • Moisture removal: condensate, drainage or venting, depending on the unit.

An accessible blockage may be suitable for authorised maintenance; internal ducts require the appropriate service procedure. Not all models have the same filters or access points.

Repair and final checks

Tests should link each component to the observed condition. If there is excessive heat or an unusual smell, stop using the appliance and investigate the cause. Resetting a thermal cut-out without correcting the cause is not a repair.

Dismantling and live electrical measurements must be carried out by competent personnel. The refrigerant circuit in a heat-pump unit requires specialist servicing. After the repair, check that the integrated function works and restore the ducts, seals and protective parts; do not adapt a procedure for a standalone dryer.

The estimate should state which part of the air, heat or moisture path is faulty and how it will be checked afterwards, rather than grouping everything under a drying problem.

View all articles in Diagnosing and repairing washing machine components