If the display switches off and returns to the start during a wash, distinguish between a power interruption and a control reset. A pause with the indicators still on requires a different diagnosis.
Observations you can note down
Note what operation it was performing when it switched off, whether other lights in your home changed, and whether the display returns to the programme or the initial selection screen. Also record any recent changes to the connections or the appliance’s location.
There is no need to repeat the incident with a heavier load or a higher temperature to identify a pattern. If there is a smell or heat damage, follow the guidance for burning or smoke.
External power supply and internal electronics
A poor connection, an interruption to the power supply, or a problem with the power source or control system can produce similar symptoms. If a protective device trips, use the electrical tripping troubleshooting guide and do not keep resetting it.
Electrolux refers power supply problems to an electrician and advises against using extension leads in its guidance on circuit load and connection. The specific circuit capacity depends on the local installation.
If the power supply has been verified
An inspection of the control board, power supply and connections should take into account external loads that could cause the fault. Do not install a generic voltage stabiliser to compensate for an unidentified fault.
How to resume a programme after a power cut varies by model. Follow the manual and check which operations were actually completed before considering the load washed.
Note whether the switch-off clears the selection or resumes the cycle; this difference helps assess the power supply and control system.
View all articles in The washing machine does not start, stops or does not finish the cycle
