F7 E1 error in Whirlpool washing machine: motor speed not reached

F7 E1 indicates a speed detection problem in the documented Whirlpool front-load washer: the motor does not reach the speed required by the cycle.

If it has just been installed or the load has changed

The manufacturer's documentation recommends checking the shipping materials and whether the machine is overloaded. If the first wash fails, check the unpacking section of the manual and confirm that the installer removed the specified transport locks. Do not run the machine to see what happens with them still in place.

If the error started with an especially large load, stop the cycle, wait for the door to unlock and reduce the load in line with the programme. Selecting a higher speed does not make a bulky item suitable for the cycle.

What the code describes and what still needs diagnosing

F7 E1 describes a speed that the control cannot confirm. By itself, it does not prove that the motor, a sensor or the electronics are faulty. Note whether the drum tries to turn, whether the fault appears when starting or spinning, and whether it began after the appliance was moved.

Only retry the procedure specified for the control panel after correcting the accessible condition. If the error returns, request service. The explanation of the speed sensor helps explain what the technician needs to check; there is no need to measure circuits or dismantle the motor.

Stop using the appliance if it makes abnormal banging noises when attempting to turn or moves out of position.

View all articles in Whirlpool washing machine error codes and alerts