Miele Error F10: restricted water inlet

F10 on the documented Miele models indicates a blocked or restricted water inlet. Check the tap, hose and accessible inlet filter before requesting a diagnosis.

If the fault started after the water was turned off

The manufacturer's documentation recommends ending the programme, opening the tap and selecting the cycle again if that was the cause. Also check whether there is a household water supply outage. An open tap alone does not guarantee that sufficient water is reaching the appliance.

Inlet hose and filter

Look for sharp bends or crushing. If the hose is damaged, do not straighten it as a permanent repair. The manual specifies when it must be replaced and which connection is suitable.

To clean a user-accessible inlet filter, first turn off the tap and prepare to disconnect it as instructed for your model. Keep the seal and mesh, and refit them after cleaning. Turn the tap back on slowly and check that the joint is watertight. See water inlet mesh filters to prepare for the task.

If the water supply is low, compare the conditions with the manual and consult the person responsible for the installation. If F10 recurs when water is available and the accessible route is clear, request service. F11 relates to drainage: do not open a pump filter just because F10 appears.

Note whether the problem started after an outage, relocation or change to the water connection.

View all articles in Miele washing machine error codes and messages