F10 error on Miele: restricted water inlet

F10 on the documented Miele models indicates a blocked or restricted water inlet. Check the tap, hose and accessible inlet filter before requesting a diagnosis.

If the fault started after the water was turned off

The manufacturer's documentation recommends finishing the programme, turning on the tap and selecting the cycle again if that was the cause. Also check whether there is a household water outage. An open tap alone does not guarantee that enough water is reaching the appliance.

Inlet hose and filter

Look for sharp bends or kinks. If the hose is damaged, do not straighten it as a permanent repair. The manual specifies when it must be replaced and which connection is suitable.

To clean a user-accessible inlet filter, turn off the tap first and prepare to disconnect it according to the model. Keep the gasket and mesh, and put them back after cleaning. Turn the tap back on slowly and check that the connection is watertight. See water inlet screens to prepare for the task.

If the water supply is low, compare the conditions with the manual and consult the person responsible for the installation. If F10 returns when water is available and the accessible path is clear, request service. F11 relates to drainage: do not open a pump filter just because F10 appears.

Note whether the problem started after an outage, a move or a change to the water connection.

View all articles in Miele washer error codes and messages