On the Miele models covered by the documentation, F10 indicates that the water intake is blocked or restricted. Check the tap, hose and accessible inlet filter before requesting a diagnosis.
If the fault started after the water was turned off
The manufacturer’s documentation recommends ending the programme, opening the tap and selecting the cycle again if that was the cause. Also check whether there is a household water supply interruption. An open tap alone does not guarantee that enough water is reaching the appliance.
Inlet hose and filter
Check for tight bends or kinks. If the hose is damaged, do not treat straightening it as a permanent repair. The manual specifies when it must be replaced and which connection is suitable.
To clean a user-accessible inlet filter, first close the tap and prepare to disconnect it as described for your model. Keep the seal and mesh, and put them back after cleaning. Slowly reopen the tap and check that the connection is watertight. See water inlet filters for help preparing for the task.
If the water supply is low, compare the conditions with the manual and contact the person responsible for the installation. If F10 returns when water is available and the accessible supply path is clear, request a service visit. F11 relates to drainage: do not open a pump filter just because F10 appears.
Note whether the problem started after an interruption, a move or a change to the water connection.
View all articles in Miele washing machine error codes and messages
