
To deal with a bad smell from the washing machine, find out where and when it occurs. Damp residue may need cleaning, while a smell of drains or burning points to other possible causes.
Start by noting when and where it occurs
Observe without leaning in to smell inside: does it occur when you open the machine after several days, when draining water, during heating or continuously in the room? Check whether it is strongest at the opening, the detergent drawer or the drain connection. Do not identify a microorganism based on how the smell is described.
| What you notice | What to check | Next step |
|---|---|---|
| Dampness and visible deposits | Seal, detergent drawer and accessible parts of the washing area | Remove residue and clean using a compatible method |
| Smell associated with water remaining in the machine | Whether draining finishes and where water remains | Address water retention before repeating cleaning cycles |
| Drain smell, especially when draining | Connection with the pipe, trap and other drains | Check the installation |
| Electrical or burning smell, or smoke | Do not run any further checks by operating the machine | Stop using the machine and follow the fault-finding guidance |
Accessible inspection of the machine
If there are no signs of danger, empty the appliance and, with the power isolated for any manual tasks, check the areas described in the manual. Inspect the folds of the seal, the detergent drawer and the drum. Only open the pump filter if access is permitted and any retained water has been dealt with.
For widespread contamination, see mould and slimy deposits. If you see material flaking off, follow the guidance on flakes and detergent residue. Disinfection requires a specific purpose and a verified method; it is not the automatic answer to every smell.
When the cause is external or you need to stop
A smell coming from the pipe may mean that the drain connectionneeds checking. If the machine shares an outlet with another appliance, check the conditions of that shared connection. Do not pour drain unblocker into the washing machine to deal with a smell coming from the plumbing.
If there is a burning smell or smoke, see what to do if you smell something electrical. Do not run an empty cycle to see if the smell goes away. A new product smell does not mean the appliance is safe either: establish whether it started after applying a product or after heating.
After cleaning
Allow the rinse and drying stages specified in the instructions to finish, then check whether the smell returns before washing or only with a load. If it soon returns despite the visible areas being clean, note the circumstances and arrange for the drain circuit or installation to be checked. If the machine does not smell but the clothes are affected, follow the guidance on smells in clothes.
Frequently Asked Questions
Can a washing machine that is clean on the outside smell from the drum?
Yes. A clean exterior tells you nothing about the condition of the drum, detergent dispenser or drainage route. Check the source of the smell within the permitted scope.
Can the smell tell you whether there is mould?
No. A musty smell can accompany various types of build-up; it does not identify species or confirm contamination throughout the machine. Inspection can guide cleaning, but it is not a substitute for analysis.
Should there be a product smell after cleaning?
Do not use fragrance as a test of cleanliness. Follow the rinsing instructions on the label and in the manual. If a strong or irritating smell persists, do not add another product or load clothes until you have established what remains.
Could the smell come from the drain even if the machine is clean?
Yes. The smell may come from the connection or drainage system. If it occurs while draining or is also noticeable elsewhere, have the installation checked instead of repeating drum treatments.
Do not mask the smell with perfumes: you would lose a useful clue as to whether the cause is still present.




