Sharing a waste pipe with a sink or dishwasher: connection requirements

Sharing a pipe is only viable if the connection and waste system are designed for the intended appliances. An adapter with two outlets does not guarantee sufficient capacity, ventilation or protection against backflow.

What the installer should check

The flow rate needs to be assessed when the appliances discharge at the same time, along with the route to the waste outlet, the function of the trap and the ventilation required. The water temperature, approved fittings and access for cleaning or servicing must also be considered.

A system that works with one appliance may overflow when another drains at the same time. The point closest to the puddle is not necessarily where the restriction is.

Suitable fittings and prepared connections

The outlets must be designed for the hose and its method of attachment. Some fittings are supplied sealed; only remove the factory seal for the outlet being used, and follow the specified procedure. Do not drill unknown parts to create a branch.

The hose needs to be secured and routed in a way that is compatible with the waste installation of the appliance. Do not treat the diameters or gradients used in another installation as a universal formula.

What to check during the combined test

The installer should check that the appliances drain without overflowing, that water does not flow back into another appliance, and that the joints are accessible. Leaks and subsequent smells need to be assessed to identify the cause; do not conceal them by sealing vents or adding a non-return valve without checking the system.

If water appears in the washing machine when the sink is used, see water backing up after draining. The timing provides useful information, but does not confirm which fitting has been installed incorrectly.

Check the system under simultaneous demand; the fact that a single discharge works does not prove that it has enough capacity to be shared.

View all articles in Washing machine installation: requirements and checks