The washing-only figure does not show the consumption for washing and drying. Compare the capacity, energy, water and duration of each mode separately, using the same load and final result.
Read both functions on the product information sheet
A washer-dryer may state one capacity for washing and another for the complete cycle. The European label for washer-dryers distinguishes between washing and complete-cycle information; other markets use their own formats. Do not automatically add two figures together without checking what each one includes.
If the energy figure for the complete cycle already includes washing, adding the washing consumption again counts it twice. If drying has been measured separately, record the incoming moisture level so that the comparison is meaningful.
Include all the loads needed
When the drying capacity means the load has to be split, the total consumption includes every load. The way an all-in-one appliance is organised can affect how soon it is available, even if one phase uses little energy.
Hypothetical example: one wash at 0.6 kWh followed by two drying cycles at 1.4 kWh each adds up to 3.4 kWh. At a variable rate of 0.25 currency units/kWh, that is 0.85 currency units. These are not figures for a specific model or typical performance.
Water and residual moisture
The drying system determines whether water can be used for condensation; this is not the same for every washer-dryer. Record the total water used over the cycle.
The amount of water retained by the clothes after spinning affects the heat required for the next stage. Compare equivalent programmes, loads and dryness levels. For the full tariff calculation method, use energy and cost per cycle.
Count every phase and load needed to deliver the same clothes in the same final condition.
View all articles in Washing machine efficiency: electricity, water and sustainability
