Calibrating a Samsung washing machine after installing or moving it

On Samsung models with a calibration function, calibration adjusts the load-detection reference. Run it with the drum empty and the machine level; it will not fix damaged parts or an unsuitable support surface.

Check the panel family before pressing any buttons

The Samsung Caribbean calibration guide distinguishes between these panels. Use a variant only if your model’s manual confirms that function and sequence:

Documented access by control family
Panel in the guideEntering the modeStarting calibration
Front-load panel with Temperature and Delay EndSwitch the machine off and on; hold both buttons for 3 seconds until Cb appearsPress and hold Start/Pause
Multi Control panel with Additional FunctionsSwitch the machine off and on; hold that button for 3 seconds, then select calibration using the dialConfirm using the button marked O
Top-load panel with Wash Cycles and Delay EndWith the machine switched on, hold both buttons for at least 3 secondsPress and hold Start/Pause
Top-load panel with Water Level and Delay EndHold both buttons for at least 3 secondsPress and hold Start/Pause

The drum moves during calibration. Depending on the variant, completion may be indicated by 0 or a calibration-complete message. Follow your manual if the controls or indicators do not match.

If the process is interrupted or the function does not appear

Check that there are no clothes or objects in the drum and that levelling has been completed. Do not try button combinations from other panels. Note the message and contact support if the process does not finish as documented.

Load detection helps control the cycle; calibration does not repair a faulty suspension or sensors. Then follow the relevant installation test.

Matching button names are not enough: confirm that your model has this calibration variant before running it.

View all articles in Commissioning and initial setup of a washing machine