The washing-only figure doesn’t describe the energy used to wash and dry. Compare the capacity, energy, water and duration of each mode separately, using the same load and final result.
Check both functions on the product information sheet
A washer-dryer may list one limit for washing and another for the full cycle. The European label for washer-dryers distinguishes between washing and full-cycle information; other markets use their own formats. Don’t automatically add two figures together without checking what each one includes.
If the energy figure for the full cycle already includes washing, adding the washing energy again counts it twice. If drying was measured separately, record the incoming moisture level so the comparison is meaningful.
Include all the loads required
When the drying capacity limit means the load has to be split, the total consumption includes every load. The operation of an all-in-one unit can affect how soon it’s available, even if one stage uses little energy.
Hypothetical example: one wash at 0.6 kWh followed by two drying cycles at 1.4 kWh each adds up to 3.4 kWh. At a variable rate of 0.25 currency units/kWh, that’s 0.85 currency units. These aren’t figures for a specific model or typical performance.
Water and residual moisture
The drying system determines whether the appliance uses water for condensation; not all washer-dryers work the same way. Record the total water used over the cycle.
The amount of water left in the clothes after the spin cycle affects the heat required for drying. Compare equivalent programmes, loads and dryness levels. For the full rate-calculation method, use energy and cost per cycle.
Count all the stages and loads needed to deliver the same clothes in the same final condition.
View all articles in Washing machine efficiency: electricity, water and sustainability
