RPM, extraction force and residual moisture: what they indicate

RPM indicates rotational speed, but does not by itself show how much water remains in the laundry. Radius, load distribution, duration, fabric and water drainage also play a part.

Speed and water extraction

During the spin cycle, the load moves with the drum and some of the water can pass through the perforations and reach the drain. The acceleration associated with rotation depends on the radius and the square of the angular speed. That is why two drums with the same RPM do not necessarily have the same extraction conditions.

The maximum shown on the control panel does not guarantee that every programme reaches it or maintains it for the same amount of time. Stability and load distribution can cause the controls to reduce the speed or repeat a redistribution cycle.

What residual moisture means

One way of expressing it is to relate the retained water to the reference dry mass, according to the test method. Illustrative example: if a dry load weighing 5 kg weighs 7.5 kg after spinning, it retains 2.5 kg of water, equivalent to 50% of its dry mass. This calculation does not assign a class without knowing which test applies.

The spin-drying efficiency classes use their own conditions. They cannot be transferred directly between methods, nor do they replace capacity per programme.

Relationship with subsequent drying

With less retained water, there is less water to evaporate if all other factors are comparable. The effect on the energy use and duration of a washer-dryer also depends on the system and the drying target.

The speed must be suitable for the fabric. Spinning does not dry clothes using heat, and a high figure does not guarantee that clothes will be ready to put away.

Compare residual moisture and test conditions alongside RPM; do not treat maximum speed as an indicator on its own.

View all articles in Washing machine efficiency: electricity, water and sustainability