Clean the machine after accidental or heavy soiling

Clean the machine after accidental or heavy soiling

After accidental soiling, first identify what was left in the machine. Remove accessible physical debris before running another cycle, but stop using the machine if there may be fuel, solvents or another unsuitable substance.

The type of residue determines what to do

ResidueFirst stepSpecific approach
Hair and fibresPick up material from accessible surfaces and collectorsPet hair
Sand, mud or particlesTell a dirty load apart from sediment in the water supplySand and mud
Paper or absorbent materialRemove scattered solids without trying to dissolve themPaper or a diaper washed by accident
DyeIdentify the dye and its cleaning instructionsDye residue
Grease or an unknown chemicalIdentify the substance before turning the machine onGrease, oils and chemicals

Prepare an empty machine

Wait until the cycle ends and the door is safely unlocked, then remove the load and check what is visible. If there has been a chemical incident, or there is a strong odour or fumes, do not open the machine for a closer look: move away and follow the product’s emergency instructions.

For residue that is safe to wash, keep the mechanisms stopped and disconnect the power before cleaning by hand. Do not push clumps into openings or the drain. Only service filters and parts that the manual says can be opened, and deal with any water before accessing a pump filter.

Treatment and follow-up check

Remove material physically before running an approved program if there is anything to pick up. A cleaner alone will not remove sand, hair or a foreign object. After cleaning, observe the empty machine and check that no residue or product remains to be rinsed away before the next load.

If the machine does not drain, makes new noises or residue returns from an enclosed area, do not run cycle after cycle to try to move it along. Arrange an inspection and report what material got into the machine. A hazardous contamination is not resolved just because the drum looks clean.

Frequently Asked Questions

Should I clean the machine after every very dirty load?

Not necessarily with a full treatment. Check what remains in accessible areas and do any cleaning required by the residue and the manual, especially if a different load is going in next.

Is it better to remove visible residue before running another cycle?

Yes, if the residue is safe to handle and accessible. Picking it up helps prevent it from going through the system again. If a hazardous chemical is involved, stop using the machine and get instructions instead.

Will an empty rinse cycle deal with every type of contamination?

No. It may flush away some kinds of residue, but it cannot guarantee the removal of solids, staining or hazardous substances, or confirm that the machine has been disinfected.

This check helps restore the machine within the scope of its approved maintenance. Cleaning affected garments requires separate decisions.