One or two inlets: connecting cold and hot water to your washing machine

Connect each inlet to the supply specified in the manual. Having only one water outlet in your home doesn’t tell you whether a washing machine with two inlets can operate with the other port capped or connected using just any kind of splitter.

Identify the inlets and requirements

A machine may be designed for cold water, cold and hot water inlets, or a special documented water supply. The connection labels and manual should confirm what each port supplies, as well as the temperature and pressure limits.

On some machines, both inlets are used in cycles that users may consider cold or warm. Whirlpool’s documentation for machines with two inlets requires both connections in its stated context; this requirement doesn’t apply to every appliance with two ports.

What can happen if you switch them

The controls may receive water that differs from what they expect, change the water mix, or fail to reach the intended temperature. This can affect both the load and the machine’s components and cycles. If an inlet doesn’t work after you connect it, the cold or hot water troubleshooting guide can help you distinguish an installation issue from a fault.

Preheated water and energy balance

The heat used for washing may come from the appliance or an external supply. Connecting water from a water heater or solar system is appropriate only if the machine is approved for those conditions. It doesn’t guarantee savings: the available temperature, heat lost through the pipes, and energy used outside the machine all matter.

If you have only one water outlet, check for an approved solution before modifying the pipes or joining the ports. Hose connections must maintain proper seals, compatibility, and access. When calculating consumption, include external energy as well if it’s part of the wash.

Confirm that the water supply is compatible before choosing adapters; the cycle settings can’t correct an improper plumbing connection.

View all articles in Washing machine installation: requirements and checks