Installing the drain hose: height, securing and siphoning

The drain hose must be positioned using the measurements and connection specified for the model. Pumped drainage and gravity drainage do not necessarily use the same routing.

Identify the type of drain connection

The drain may connect to a standpipe, a designated trap connection or a sink. The installation must accommodate the flow rate and temperature of the discharged water and maintain the required protection against backflow. The connection for a portable washer may be temporary and secured differently.

Manual specifications to follow during installation

  • Minimum and maximum height, if specified, and the point from which they are measured.
  • Insertion depth and whether an air gap is required.
  • Routing length and approved extensions.
  • Bend radius, support and securing method.
  • Accessories and type of connection to the building drain.

The hose must stay in place without being crushed. Sealing a standpipe completely or inserting the hose too far can interfere with the intended ventilation. Specifications for another brand are not a substitute for those of your appliance.

Why it may drain while filling

Incorrect routing can create a siphoning flow. If the drain relies on gravity, the difference in height plays a different role, and copying an elevated hose route may prevent drainage. The hydraulic circuit helps distinguish between the two designs.

With a shared drain, capacity and backflow between appliances must also be checked. If the machine fills and drains at the same time, note what happens and check the connection without assuming that the pump has failed.

Before testing, compare the entire hose route with the manual illustration, including the washer's final position.

View all articles in Washing machine installation: requirements and checks