Sharing a pipe is only viable if the connection and drainage system are designed for the intended appliances. An adapter with two outlets does not guarantee adequate capacity, venting or protection against backflow.
What the installer should check
The installer must assess the flow rate when both appliances drain at the same time, the route to the drainage system, the trap’s function and the required venting. Water temperature, approved fittings and access for cleaning or servicing must also be considered.
A system that works with one appliance may overflow when another drains at the same time. The spot closest to the puddle is not necessarily where the restriction is.
Purpose-designed fittings and connections
The outlets must be designed for the hose and its fastening method. Some fittings are supplied with plugs; only remove the factory plug for the outlet being used, and follow the specified procedure. Do not drill unknown parts to create a branch.
The hose must be secured and routed in a way that is compatible with the appliance drain installation for the appliance. Pipe diameters or slopes from another installation should not be treated as universal prescriptions.
What to look for when testing both appliances together
The installer should check that water drains without overflowing, that it does not flow back into the other appliance, and that the joints are accessible. Leaks and subsequent odours need to be assessed to determine their cause; do not conceal them by sealing vents or adding a backwater valve without checking the system.
If water appears in the washing machine when you use the sink, see water backing up after draining. The timing provides useful information, but does not confirm which fitting is incorrectly installed.
Check the system under simultaneous demand; a single drain cycle working properly does not demonstrate that it has enough capacity to be shared.
View all articles in Washing machine installation: requirements and checks
