How to set up automatic detergent and fabric softener dosing

Automatic dosing needs to know which product it contains and how concentrated it is. Filling the reservoir without checking its settings can result in an incorrect dose, even if no warning appears.

Set it up with the product container on hand

  1. Identify which reservoir is for detergent and which is for fabric softener or a second product, if your model allows it.
  2. Check which product formulations and consistencies are approved. Don’t put pods, powder or liquids that aren’t intended for a different format into the dispenser.
  3. Set the concentration or base dose by following the exact procedure in the manual. A product label such as “concentrated” doesn’t always correspond to a numerical scale on the machine.
  4. Enter water hardness and soil level settings when prompted, using actual values.
  5. Check the dosing indicator before the first wash, then observe the results.

Switch to manual dosing

A special load, such as wool, may require a different detergent. If you use the manual compartment, disable the corresponding reservoir as directed and confirm its status. Don’t assume that adding product manually automatically cancels automatic dosing.

Changing products or resuming use

Check whether the reservoir and its dispenser system need to be emptied or cleaned before changing products. Mixing leftover formulations or topping up thickened detergent won’t correct an incorrect calibration. Follow the system’s maintenance instructions for cleaning.

If residue is left on your laundry, first check the product actually used, the selected concentration and whether an extra dose was added accidentally. Adjust only as directed for the machine; don’t make up multipliers to correct the results.

Before a special load, confirm which reservoirs are still active. This check helps prevent accidentally combining automatic and manual dosing.

View all articles in Laundry detergents, dosing and additives