Sud LOC indicates a pause related to excess suds on the documented Fisher & Paykel front-load washers. Allow the specified recovery process to finish before treating the extended cycle as a fault.
The WH7560P1/WH8560P1 and WH7560J1/WH8560J1 manual describes an automatic ten-minute wait before resuming. This behaviour applies to those model families, not all Fisher & Paykel washers.
What to do during the pause
If there is no leak or other alarm, follow the recovery steps in the manual without adding detergent or homemade suds-control products. Opening the washer or turning it off to shorten the wait may interrupt the intended process.
If there is water outside the washer, address the leak and avoid contact with wet electrical components. Don’t keep waiting solely because Sud LOC is a suds warning.
Correct how you use the washer before the next load
Check that the detergent is suitable for a front-load washer and measure the dose according to the product, load size and soil level. A more concentrated formula or a small load may require less detergent. See detergent dosing and suds control to adjust these habits.
If the warning recurs after you’ve corrected how you use the washer and followed the approved recovery process, request an inspection; don’t conclude that the pump is damaged based on an isolated suds issue.
Record how much detergent you added and whether residue from a previous wash remained, so you can explain a recurring Sud LOC warning.
View all articles in Fisher & Paykel washer codes and alerts
