EH0/EHO on Electrolux washers refers to the power supply. The error family distinguishes EH1 for frequency out of range, EH2 for high voltage and EH3 for low voltage.
Distinguish a supply issue from an appliance fault
The manufacturer’s documentation confirms these subcodes, but the control panel is no substitute for a professional electrical inspection. Note whether other appliances also experienced interruptions or if the fault started after the connection was changed.
Visually check a direct connection, without an extension cord or improvised adapters. Don’t open the outlet or test another appliance if there is heat, an odour, damage or moisture. If the circuit protection trips, stop trying and arrange an inspection.
Reset only if there are no signs of damage
Support recommends unplugging the washer for 30 to 60 seconds and selecting a programme again when the connection is dry, accessible and safe. Check the manual for your PNC; if the error returns, don’t keep unplugging the washer repeatedly.
An issue affecting the electrical installation should be handled by an electrician. If the power supply has been verified and only the washer is affected, arrange appliance service. The guide to the washer outlet and circuit protection explains what the installation should be checked for, without assuming a universal voltage.
Report the error suffix: frequency and voltage describe different conditions.
View all articles in Electrolux washer error codes and alerts
