Prewash and soaking in the washing machine: when to use them

Prewash adds a preliminary cleaning stage; soaking keeps the load in contact with water or a washing solution for a set time. The manual determines whether these stages drain water, dispense product or continue into the main cycle.

What problem are you trying to solve?

A load with a lot of loose dirt may need it removed before the main wash. A set-in stain may need contact with a pre-treatment product. These are not the same situation: soaking sand or solids does not remove material that should be taken out first.

Check that the fabric and its colour can tolerate the treatment, and that the product label allows soaking or prewashing. Embellishments, dyes or attached layers may limit prolonged contact, even if the garment can tolerate a brief wash.

Set up the stages without doubling the dose

  1. Remove loose dirt in a way that is suitable for the garment.
  2. Check which function the machine offers and how it continues to the main wash.
  3. Divide the detergent between stages only as directed by the product and appliance instructions. Identify the relevant compartments.
  4. Select the subsequent cycle and make sure its rinse and spin settings are suitable.

Do not fill an automatic machine manually or unplug it to create an indefinite soak. If it does not have this function, use only an approved alternative. Stain preparation helps you decide when treating one area is enough, rather than subjecting the whole load to the same process.

Clothing contaminated with biological material requires its own handling and hygiene guidelines. Soaking alone does not demonstrate disinfection.

View all articles in Washing machine programmes, settings and controls