Prewash and soaking in the washing machine: when to use them

Prewash adds a cleaning stage before the main wash; soaking keeps the load in contact with water or a washing solution for a set time. The manual specifies whether these stages drain water, use detergent or continue into the main cycle.

What problem are you trying to solve?

A load with a lot of loose dirt may need it removed before the main wash. A set-in stain may need contact with a pre-treatment product. These are not the same situation: soaking sand or solid particles does not remove material that should be taken out first.

Check that the fabric and its colour can withstand the treatment, and that the product label allows soaking or prewashing. Trims, dyes or bonded layers may limit prolonged contact, even if the garment can tolerate a short wash.

Set up the stages without doubling the dose

  1. Remove loose dirt in a way that is suitable for the garment.
  2. Check which function the machine offers and how it continues to the main wash.
  3. Distribute the detergent between stages only as directed by the product and appliance instructions. Identify the relevant compartments.
  4. Select the subsequent cycle and complete a compatible rinse and spin.

Do not fill an automatic washing machine by hand or disconnect it to create an indefinite soak. If it does not have this function, use only an authorised alternative. Stain preparation helps you decide when treating one area is enough, without putting the whole load through the same process.

Laundry contaminated with biological material requires its own handling and hygiene guidance. Soaking alone does not prove that disinfection has taken place.

View all articles in Washing machine programmes, settings and controls