Place each product in the compartment and at the stage indicated by both its label and the manual. The fabric softener compartment, the main wash compartment and a bleach dispenser are not interchangeable.
Identifying the dispenser
I usually indicates prewash, II the main wash and a flower the fabric softener, but these are conventions that you should confirm against your model’s key. Some machines have a separate chlorine bleach dispenser; others dispense products directly into the drum or from automatic dosing reservoirs.
- Check which compartments your machine has and which function is active.
- If you use liquid detergent, check the position of any insert the drawer may require. Do not fit parts from another model.
- Measure the product dose. Stay within the compartment’s maximum capacity, which is not the same as a recommended dose.
- Close the drawer as instructed in the manual and check that no concentrated product remains on clothes or surfaces.
Products that go in different places
Laundry capsules may be intended for the drum; do not put them in a liquid detergent reservoir because of their contents. Fabric softener usually works during the rinse cycle and needs its own dispensing route. For chlorine bleach, use only an approved arrangement.
For prewash, check how the product is distributed between stages. With a delayed start, check that it will not leak out too early or remain on a garment. If the dispenser does not empty, distinguishing incorrect placement from dirt or a fault requires further checks; changing compartments will not fix the problem.
If the product remains in the dispenser, investigate how it is meant to dispense; using another compartment may release it at the wrong stage.
View all articles in Laundry detergents, dosing and additives
