Prewash and soaking in the washing machine: when to use them

Prewash adds a cleaning phase before the main wash; soaking keeps the load in contact with water or a washing solution for a set period. The manual specifies whether these phases drain water, dispense product or connect to the main cycle.

What problem are you trying to solve?

A load with a lot of loose dirt may need to have it removed before the main wash. An embedded stain may require contact with a pretreatment product. These are not the same situation: soaking sand or solids does not make the material that should be removed first disappear.

Check that the fabric and its colour can tolerate the treatment, and that the product label allows soaking or prewashing. Embellishments, dyes or bonded layers may limit prolonged contact, even if the garment can tolerate a short wash.

Set up the phases without doubling the dose

  1. Remove loose dirt in a way that is safe for the garment.
  2. Check which function the appliance offers and how it proceeds to the main wash.
  3. Distribute detergent between phases only as directed by the product and appliance. Identify the corresponding compartments.
  4. Select the following cycle and complete a compatible rinse and spin.

Do not fill an automatic washing machine manually or disconnect it to create an indefinite soak. If it does not have this function, use only an approved alternative. Stain pretreatment helps you decide when treating one area is enough, without putting the entire load through the same process.

Laundry contaminated with biological material requires its own handling and hygiene guidelines. Soaking alone does not prove disinfection.

View all articles in Washer cycles, settings and controls