Place each product in the compartment and at the stage indicated by both its label and the manual. The fabric softener compartment, the main-wash compartment and a bleach dispenser are not interchangeable.
Identifying the dispenser
I usually indicates pre-wash, II the main wash and a flower the fabric softener, but these are conventions that you should confirm in the model guide. Some machines have a separate chlorine bleach dispenser; others dispense products directly into the drum or through automatic dispensers.
- Check which compartments your machine has and which function is enabled.
- If you use liquid detergent, check the position of the insert that the drawer may require. Do not insert parts from another model.
- Measure the product dose. Do not exceed the compartment's maximum capacity, which is not the same as a recommended dose.
- Close the drawer as instructed in the manual and check that no concentrated product remains on garments or surfaces.
Products that do not go in the same place
capsules may be intended for the drum; do not put them in a liquid detergent dispenser because of their contents. Fabric softener usually acts during the rinse cycle and needs its own dispensing route. For chlorine bleach, use only an authorised arrangement.
For a pre-wash, check how the product is distributed between cycles. With a delayed start, make sure it will not be released too early or left on a garment. If the dispenser does not empty, distinguishing incorrect placement from dirt or a fault requires further checks; switching compartments will not fix the problem.
If the product remains in the dispenser, check how it is supposed to be dispensed; using another compartment may release it during the wrong cycle.
View all articles in Detergents, dosing and laundry additives
