The drum has play, is off-centre or has dropped

The tub assembly can move on its suspension; that is not the same as play in the inner drum relative to the tub. If the drum is permanently off-centre, rubbing or dropped, stop using the appliance.

Observe which part is moving

Disconnect the appliance before making any accessible observations. For a horizontal-axis drum, distinguish between movement of the entire suspended assembly and movement of the inner drum relative to it. Don’t lift it forcefully or assume there is a universal tolerance: behaviour depends on the design.

Note whether the gap around the opening is uneven, whether there are marks on the seal, or whether slight movement causes contact. Don’t run a spin cycle just to document a banging noise that is already obvious.

What the service technician should check

The suspension supports and controls the tub assembly. The bearings and the support or shaft help support the inner drum. Identifying which mechanical relationship has changed helps ensure the right assembly is inspected.

Wear or damage can affect more than one area. If a rubbed seal is replaced without correcting the drum’s off-centre position, contact may recur. A door leak accompanied by rubbing should be described along with the play.

Useful information for assessing the repair

Provide the model, when the problem started, whether there was increasing noise or a sudden bang, and whether there had been any previous leaks. The technician should confirm the damage and availability of the relevant assembly before providing a quote.

Levelling the feet won’t correct a drum that moves relative to its own internal supports.

View all articles in Rotation, agitation and spin faults