The tub assembly can move on its suspension; that is not the same as play between the inner drum and the tub. If the drum is permanently off-centre, rubbing or sagging, stop using the appliance.
Notice which part is moving
Unplug the appliance before making any accessible observations. In a horizontal-axis washer, distinguish between movement of the entire suspended assembly and movement of the inner drum relative to it. Don’t lift forcefully or assume there is a universal tolerance: how it moves depends on its construction.
Note whether the gap around the opening is uneven, whether there are marks on the seal, or whether slight movement causes contact. Don’t run a spin cycle just to document a thumping sound that is already obvious.
What the service technician should check
The suspension supports and controls the tub assembly. The bearings and the support or shaft help support the inner drum. Identifying which mechanical relationship has changed helps ensure the right assembly is inspected.
Wear or damage can affect more than one area. If a rubbed-through seal is replaced without correcting the off-centre position, contact may occur again. A door leak accompanied by rubbing should be described along with the play.
Useful information for assessing the repair
Provide the model number, when the issue started, whether there was increasing noise or a sudden thump, and whether there had been any previous leaks. The technician should confirm the damage and the availability of the required assembly before providing an estimate.
Levelling the feet won’t correct a drum that is moving relative to its own internal supports.
