The washing machine won’t turn on and shows no lights

A washing machine that is completely unresponsive may have no power supply or an internal power or control fault. A dark display alone does not prove that the control board is faulty.

First, rule out a dangerous situation

If you notice water near electrical connections, burn marks, a damaged cord or an electrical smell, do not plug the appliance in again. Isolate the power from a safe location and arrange an inspection.

External checks

Check the power switch position and whether the installation has an accessible, designated appliance switch. Check whether there was a known power outage and which other points lost power, without dismantling the power point or inserting anything into it.

Check the cord and plug only from a dry position, without moving a heavy machine or pulling on the cord. If a safety switch or circuit breaker has tripped, see the guide to electrical trips rather than resetting it repeatedly.

Bosch lists the power supply and door among the causes of a machine not starting in its starting problems guide. In this case, no indicators at all point first to a power supply issue; an active panel that won’t start is covered by a different diagnosis.

If the power supply is working

The internal power supply, mains filter, connections or electronics should be checked using the applicable wiring diagram. Don’t use an extension lead, adaptor or makeshift power point to get around a possible circuit problem.

If the power point hasn’t been checked or the cord is damaged, have the electrical issue attended to before attributing the lack of lights to the appliance.

View all articles in Electrical and heating faults in washing machines