How to reset a washing machine and when it may help

A reset may restore a control state, but it won’t fix a leak, blockage or damaged part. Before doing so, note the message and check for any signs of danger.

Four different actions

ActionWhat changes
Cancel the cycleStops operation using the controls and may start draining or a waiting period
Reset the powerSwitches the appliance off and back on using the permitted procedure
Reset settingsMay erase preferences or connections, depending on the model
Enter diagnosticsAccesses checking functions; this is not the same as a household reset

Before following a sequence

Keep a record of the exact code, programme, cycle stage and any visible water. Check for leaks, electric shocks, smoke, odours or unusual heating. If any of these occur, stop using the machine rather than trying to clear the warning.

Check the manual for your model and market for the button presses and wait times. There is no universal combination, and unplugging the machine does not necessarily release the door immediately.

How to interpret the result

If the controls start working again, check what the original condition was: failure to start, cycle stopping or unresponsive panel. If the fault returns, the reset has restored a state without removing the cause.

Don’t repeat the operation in a loop or try technical modes from unknown sources. Some functions change settings that users don’t need to adjust.

Use the permitted recovery procedure as a specific troubleshooting step, not as proof that the washing machine has been repaired.

View all articles in Washing machine won’t start, stops or won’t finish the cycle