The washing machine stops halfway through the cycle

A stop after starting should be interpreted in light of the phase and the state of the control panel. Soaking or load balancing may involve pauses; if it stops and stays stopped, you need to identify which operation was pending.

Record the state before taking action

Note whether there is water inside, whether the door is still locked, whether an error is displayed and which operation had started. Check whether the machine remains switched on or whether all the indicators have gone out.

If there is an odour, a leak or abnormal heating, stop using the machine and isolate the power from a safe location. Do not complete the record by running test cycles.

Guidance by phase

  • If it pauses after trying to fill, note whether any water entered and how much is visibly inside.
  • If it stops before speeding up with water still inside, check draining.
  • If it does not get through a documented heating phase, the heating should be investigated without using the glass as a thermometer.
  • If the lights go out or the home screen returns, continue with power loss and restarts.

A stop versus a cycle that keeps running

A machine that pumps, refills or repeatedly tries to spin without finishing is a case of repeating phases. This is not assessed in the same way as a machine that falls silent while displaying a warning.

Compare the pause with the manual and the machine's usual behaviour. There is no single time limit that makes every wait a fault.

If the same programme stops again at the same point after you correct an identified condition, give that pattern to the service technician and do not keep restarting the machine.

View all articles in Washing machine won’t start, stops or won’t finish the cycle